|
HP LASER PRINTER ERROR CODE 53
ACCESSORY MEMORY ERROR.
HP LASER PRINTERS 2, 2D
1. Accessory memory failure.
2. Replace memory card
HP LASER PRINTERS 3, 3D
1. Failure in front memory slot.
2. Failure in rear memory slot.
3. Replace memory card
4. Replace formatter board.
HP LASER PRINTERS 2P, 2P+, 3P
1. Replace top memory card.
2. Replace bottom memory card.
HP LASER PRINTERS 3SI, 4SI
1. Temporary error.
2. Laser malfunction (see error 51 page)
HP LASER PRINTERS 4, 4+, 4P, 4SI, 4V, 5
1. SIMM malfunction.
2. Replace simm's chip.
3. Replace formatter board.
HP LASER PRINTERS 4L, 5L
1. An error has been found in the RAM.
2. Defective or incompatible memory card.
3. Defective formatter board.
HP LASER PRINTERS 5P, 5SI
1. SIMM malfunction.
2. Replace simm's chip.
3. Replace formatter board.
HP LASER PRINTERS 1200, 2200, 3100, 3200, 4100 ERROR 53.XX
1. Temporary error. DIMM error.
2. Unsupported memory size.
3. Invalid DIMM speed. 4.
DIMM RAM parity error. 5. Try the dimm in a different
slot. 6. Unable to
make a temporary mapping in the printer.
7. Replace all the DIMM
memory. 8. MAKE SURE YOU
ARE NOT TRYING TO USE COMPUTER MEMORY IN YOUR LASER PRINTER. IT IS NOT
A COMPUTER!
9. Replace formatter board.
HP LASER PRINTER ERROR 2300
53.XX.ZZ
1. The printer has a problem
with the memory DIMM.
2. Unsupported memory presence
detect bad. 3. Reseat
all the memory on the mother board. 4.
Unsupported memory size. Means the DIMM you trying to put in slot is
too many MB. per DIMM for the printer. Basically you are trying to put
computer memory in to a printer, GET IT OUT AND GO BUY HP PRINTER
MEMORY!
HP LASER PRINTER 5000, 5150
1. Error has occurred on some
memory.
2. Unsupported memory.
3. Unrecognized memory.
4. Exceeded maximum ram size
5. Invalid dimm speed. 6.
Remove dimm and put into different slot. 7.
Replace bad dimm chip that caused the error HP
LASER PRINTER 4200, 4300 1.
An error occurred in the printer memory. 2.
Unsupported memory. 3.
Unrecognized memory. 4.
Unsupported memory size. Means the DIMM you trying to put in slot is
too many MB. per DIMM for the printer. Basically you are trying to put
computer memory in to a printer, GET IT OUT AND GO BUY HP PRINTER
MEMORY! 5.
Reset all DIMMS. 6.
Replace the bad DIMMS. 7.
Replace the mother board. HP
LASER PRINTER 8100, 8150
1. Error has occurred on some
memory.
2. Unsupported memory.
3. Unrecognized memory.
4. Exceeded maximum ram size
5. Invalid dimm speed.
6. Dimm rom needs to be mapped
to an unsupported address. 7.
Dimm address conflict. 8.
Unable to make a temporary mapping. 9.
Remove dimm and put into different slot. 10.
Replace bad dimm chip that caused the error
HP COLOR LASER PRINTER 4500, 4550
1. Temporary dimm error.
2. Replace dimm chip.
3. Replace formatter board.
HP COLOR LASER PRINTER
4600, 5500 ERROR CODE 53.XO.ZZ
1. An error has occurred in
the onboard RAM.
2. Turn the printer on and
then off.
HP COLOR LASER PRINTER
4600, 5500 ERROR CODE 53.XY.ZZ
1. Error has occurred on some
memory.
2. Unsupported memory.
3. Unrecognized memory.
4. Exceeded maximum ram size
5. Invalid dimm speed. 6.
Remove dimm and put into different slot. 7.
Replace bad dimm chip.
8. Replace the formatter
board. HP COLOR
LASER PRINTER 4600, 5500 ERROR 53.10.05 1.
A DIMM is installed in both 168 - pin DIMM slot 4 and 100 - pin DIMM
slot 5. 2. Remove
one or all the DIMMS, or move one of the DIMMS to a different
slot.
HP COLOR LASER PRINTER 8500
1. Temporary dimm error
2. Try dimm chip in a
different slot. The DRAM DIMMS must be installed in synchronous pairs in
adjacent slots, with the same size and speed in both slots. Only SDRAM is
supported.
3. Replace dimm chip.
4. Replace formatter board.
.
HP LASER PRINTER 9000
1. Temporary dimm error
2. Try dimm chip in a
different slot
3. Replace dimm chip.
4. Replace formatter board.
|
